COMPASS
Guided calibration
Heading in degrees
North-South indicator - North indicator
Tilt compensation up to 45 degrees OTHER
Backlight option for night use
Backlight type - Electo-luminescent display
Operating temperature - -10°C - +60°C/+14°F - +140°F
Sapphire crystal glass
Selectable metric/imperial units
Storage temperature - -30°C - +60°C/-22°F - +140°
Water resistance - 100m / 300ft with underwater buttons
Weight - 95g with leather and rubber straps
Replaceable straps - By authorized retailer
POWER
Low battery warning SPECIAL
Button lock
✓
WATCH
12/24h
Calendar clock
Daily alarms - 1 CHRONOGRAPH
Race timer - 99d 23h
Race timer resolution - 0,1s (0-60s); 1s (1-59min); 1min (1-24h); 1h (1d or more)
Sailing timer - 60 min
Stopwatch WEATHER
Barometer graph - 12 h
Barometer graph memory - 24 h
Barometer range - 300-1100 hPa/8.9 -32.5 inHg
Barometer resolution - 1 hPa/0.03 inHg
Storm alarm - Visual
Absolute air pressure QUICK GUIDE
CHANGING SETTINGS
Enter and exit the settings by holding the crown pressed. Change values by rotating the crown. Accept and move to the next values by pressing the crown once. USING BACKLIGHT & BUTTON LOCK
Turn on the backlight by keeping the middle button pressed. Activate and deactivate the button lock by pressing the crown and the middle button simultaneously. USING SAILING TIMER & RACE TIMER
Switch between TIME and SAILING TIMER by pressing the middle button. Activate the SAILING TIMER by pressing the crown once. It will start counting downwards from the present time and give a signal for each critical moment. Synchronize to the next full minute by pressing the lower button. When reaching zero, the SAILING TIMER turns into a RACE TIMER and starts to count upwards. Stop the timers by pressing the crown once and reset by keeping the lower button pressed. BROWSING AIR PRESSURE GRAPH
Browse the recorded absolute air pressure graph readings by rotating the crown downwards. Exit by pressing the middle or lower button. USING THE COMPASS
Activate the COMPASS with the lower button. North is indicated in the outer rim segment and current heading is shown in numbers. CALIBRATING THE COMPASS
Start the compass calibration by holding the lower button pressed when the compass is activated. First, keep the device level and with a steady pace rotate it until the outer segments are filled. “LEVEL” blinks on the display if the device is not level or stable. When successful, the device gives a signal and automatically starts the tilt calibration. Keep the device tilted 90˚ until the device sounds and informs if the calibration is successful (”OK”) or not (”FAILED”). |
